PS GPS

Yes, first of all do you know what ports does your camera uses, I mean TCP or UDP port #. Unless there is a special software that you install in your computer??? If that is the case well you will have to enable remote desktop on that computer and make a port forwarding rule for port 3389 in your router. So in your router you will have a port forwarding rule that says: “Whenever there is an incoming traffic from the internet with port 3389, then forward it to this computer’s IP address. There are many ways to see a camera remotly, so what is the method to see your cameras from your internal network???

Now, about your hard drive. How is your hard drive advertised in your network, what is the IP address that is using. I assume that it will be using your routers IP address, but it might not. So first of all you need to know what is the IP address that hard drive has. Once you know that the you go to Start, then click on run and type \\Hard_Drive_IP_Address replace that with the actual hard drive IP address, don’t forget to put \\